Ignition problems/ 1994 conv 900s

Grunff wrote:
> TonyF wrote:
> > After replacing my crank pulley my car will not start. I then put in
> > new ignition cables, coil, rotor and distributor cap.
> > Still will not start. I don't seem to be getting any spark. Any
> > suggestions
>
> Need more info. Are you saying you changed the crank pulley, did nothing
> else, and it wouldn't start? Turns over, but no start?
>
>
> --
> Grunff

Exactly. turns over but will not start. Yesterday i removed the crank
pulley again to inspect the plate that mounts on the back of the
pulley, it's damaged. I have a new one on order and think this might be
the problem. From what i understand it tells the ignition system when
the #1 cylinder is in the correct position.
 >> Stay informed about: Ignition problems/ 1994 conv 900s 

Look at the Security system. If the motor turn but does not start they
ignition breaker is still operating. I dont have the english word for it so
I can only hope you understand what I mean.

Pieter
"TonyF" <tony_fassett RemoveThis @comcast.net> schreef in bericht
news:1122055687.731379.193070@g14g2000cwa.googlegroups.com...
>
> Grunff wrote:
>> TonyF wrote:
>> > After replacing my crank pulley my car will not start. I then put in
>> > new ignition cables, coil, rotor and distributor cap.
>> > Still will not start. I don't seem to be getting any spark. Any
>> > suggestions
>>
>> Need more info. Are you saying you changed the crank pulley, did nothing
>> else, and it wouldn't start? Turns over, but no start?
>>
>>
>> --
>> Grunff
>
> Exactly. turns over but will not start. Yesterday i removed the crank
> pulley again to inspect the plate that mounts on the back of the
> pulley, it's damaged. I have a new one on order and think this might be
> the problem. From what i understand it tells the ignition system when
> the #1 cylinder is in the correct position.
>
 >> Stay informed about: Ignition problems/ 1994 conv 900s